OMNIE FoilBoard Floating system is laid over a flat & even solid floor. The universal panels provide the support for the fully floating floor deck that is laid over. Each panel is manufactured from extruded polystyrene insulation (XPS) which has a high compressive strength, suitable for floating floor applications. The heat diffusers are pre-bonded and made from soft temper aluminium. As no thick rigid plates are used the panels are easily trimmed on site. Once the panels are in place, the pipe is pressed into the channels piercing the foil diffuser. To complete the floor a tongue and groove deck or floor finish is laid over. The product is available in standard thicknesses of 18, 25, 35 & 50mm. It is not recommended that tiles are used as the floor finish in floating floor constructions. Instead refer to our FoilBoard Batten or Omnie Ultimate products.
OMNIE FoilBoard Floating system using 12mm (18mm FoilBoard only) or 16.5mm PE-RT pipe to DIN 4726 installed into FoilBoard panels comprising of XPS extruded polystyrene with pre-bonded heat diffusers to be installed as a continuous insulation layer to support a fully floating floor. Tongue and groove floor deck to be laid over. The system to be designed, installed and commissioned to BS1264.
ULTRALOW – This product is part of our low build up range.
For more information on UltraLow Technology see Datasheet – DS UFH 23
LAYFAST – Speed up installation time. This product uses our multi directional pipe channel system.
For more information see Datasheet – DS UFH 22
Foilboard Floating Panel
Weight with water
Existing Floor Requirements
Heat outputs below are based on 16.5mm PE-RT pipe at 150mm centres with 18mm chipboard laid under 15mm wood and carpet & underlay. Air Temperature = 20°C.
(0.15 m²K/W = 1.5 TOG).